The following are areas of concern that could impact the quality of installation on your Starrco pre-engineered office system. By examining these areas early and clearly indicating them on a drawing with dimensions keyed to your office layout, Starrco can better fill your customers needs.
Building columns: Note locations, orientations, sizes of columns and base plates.
Floor condition: Note any unusual aspects such as excessive slope, uneven sections, or curbs. Is floor sufficient for point loads if load-bearing applies?
Overhead obstructions: Note any sprinkler pipes, electrical conduit or trays, overhead cranes, or conditions such as a leaking roof.
Existing walls: Note wall type and any existing attachments to the wall such as conduit, water pipes, circuit breaker boxes, etc. Are there any areas we are attaching to which are recessed or require special attention?
Existing windows or doors: Note locations and dimension. Describe what dimensions are taken from such as block wall or mullions. Be aware of heights and sizes which may infringe on ceiling placement or attachment of dust cover support angle.
Manufacturing process: Note traffic aisles and be aware of door swings. Be aware of processes that may produce unwanted conditions such as excess heat or moisture and describe. Note areas where condensate lines for thru-wall air conditioning may empty. Are there excessive air borne debris that may impede the proper performance of air conditioners. Will there be excessive heat loads inside this office which should be considered in sizing the correct a/c?
Addressing these areas early not only helps to insure that the office is pre-engineered properly, but could also point out areas where additional labor may be incurred. The above items are meant to be used as a guideline and may not be inclusive of all conditions which may be encountered.
Would you like to share a testimonial about Starrco Products? Please send your testimonials to lisa@starrco.com and we'll publish them on our site!
